IMAPSieve (imap-sieve) Plugin

As defined in the base specification (RFC 5228), the Sieve language is used only during delivery. However, in principle, it can be used at any point in the processing of an email message.

RFC 6785 defines the use of Sieve filtering in IMAP, operating when messages are created or their attributes are changed. This feature extends both Sieve and IMAP.

Therefore, Pigeonhole provides both an IMAP plugin and a Sieve plugin.

The sieve_imapsieve plugin implements the imapsieve extension for the Sieve filtering language, adding functionality for using Sieve scripts from within IMAP.

The imap_sieve plugin for IMAP adds the IMAPSIEVE capability to the imap service. The basic IMAPSIEVE capability allows attaching a Sieve script to a mailbox for any mailbox by setting a special IMAP METADATA entry. This way, users can configure Sieve scripts that are run for IMAP events in their mailboxes.

Beyond the standard, the Pigeonhole implementation also adds the ability for administrators to configure Sieve scripts outside the user's control, that are run either before or after a user's script if there is one.

Note

The imapsieve extension can only be used in a Sieve script that is invoked from IMAP. When it is used in the active delivery script, it will cause runtime errors. To make a Sieve script suitable for both delivery and IMAP, the availability of the extension can be tested using the ihave test (RFC 5463) as usual.

Configuration

imap-sieve

The IMAP plugin is activated by adding it to the mail_plugins setting for the imap protocol:

protocol imap {
  mail_plugins = $mail_plugins imap_sieve
}

This will only enable support for administrator scripts.

User scripts are only supported when a Sieve URL is additionally configured using the imapsieve_url setting. This URL points to the ManageSieve server that users need to use to upload their Sieve scripts. This URL will be shown to the client in the IMAP CAPABILITY response as IMAPSIEVE=<URL>.

sieve-imapsieve

The Sieve plugin is activated by adding it to the sieve_plugins setting:

sieve_plugins = sieve_imapsieve

This plugin registers the imapsieve extension with the Sieve interpreter. This extension is enabled implicitly, which means that it does not need to be added to the sieve_extensions setting.

Settings

imap-sieve

sieve-imapsieve

There are no dovecot.conf settings for this plugin.